DIY Steampunk Goggles – Tutorial

Mr Hudson's Goggles

I don’t know who it is who is spreading these scurrelous rumours about my fondness for goggles – but I really do hope they continue!  *chuckles*  Mr Hudson is a photographer, and intends to do a bit of Steampunk portraiture for his own satisfaction at some point in the future, but found that good Steampunk props were somewhat hard to find.  So, he’s making his own!  (Good on you, sir.)  Above, are the goggles that he has managed to make without the use of advanced powertools or the equivalent, and requires merely purchasing a few things from a DIY shop and perhaps a second hand belt.

He’s written up a very well done tutorial on how you might go about making your own goggles – though he does advise not to do as he did, and cut through his protective cardboard and into the dining tabletop.  Unfortunate.  He’s seeking suggestions for replacement lenses, though, so if you have any ideas, feel free to comment here or perhaps contact Mr Hudson himself.  Lovely work, Mr Hudson – it’s going to be a very interesting photograph when you’re done!

  • dantes_torment
    I honestly did this several months ago. Only with the bottoms of two Red Bull cans and some electrical tape. If you do it that way, you can work the plastic (I use the clear part of a CD case, because it works best) so that you need no glue or anything. it'll pop right into that "basin" on the bottom of the can.
  • Kraken Onironauta
    LOL, man, totally forgot to say it, but I love the project! It looks really cool! I'm going to try it out and get me one of those :) thanks a lot for the link/tutorial!
  • Kraken Onironauta
    I'm an architecture student, and I build lots of models for projects. Home Depot here carries several kinds of acrylic plaques, the smallest ones are about 30x40 cms, and you can find them in 2 mm to 5 mm, most of the time. Cutting acrylic is not all that easy, but you can mark your cut with a cutter and they also sell this hooked cutters for acrylic hat makes the cutting easier. Or you can just cut and cut and cut with the regular cutter, it works too. You can even get the acrylic tinted.

    If you know an acrylic mayorist or producer, they might have left overs from bigger pieces they sell really cheap or give away for free. If you need to glue it, plastic cement or UHU do the job, though there's special acrylic cement too.
  • Sviatoslav
    Nice work on the goggles, very inventive and resourceful to look at escutcheons for the frames.

    You can buy replacement round lenses for welding goggles and safety glasses which are made out of some sort of plastic. Perhaps purchase some of these and cut them down to the correct size if required. They are quite cheap, like $2 for a pair.

    Cheerio!

    Sviat
  • Must...find...escutcheon...

    Anyone know any specifics that might help a US-based maker find such things?
  • I wonder if you could not get some of those small round magnifying glasses, and use the 'lenses' out of those. It'd be useful for doing close up work.
blog comments powered by Disqus